ESATStatus in General
ESATStatus a utility to show the status of the XWall
queues and more wherever you are. Set your warning and
alert levels for each individual queue. A quick glance
at the screen and you know what's going on.
These are the same queue levels as shown on the blue
XWall window when XWall runs as an application. However
as with any service XWall in service mode displays nothing
to the screen.. So you really don't see what's going
on. ESATStatus will display the XWall queue levels on
your server screen, your workstation, your home computer,
laptop or just about on anything else with the Microsoft
.NET environment.
Features
The Configuration Panel is activated by clicking
on the ESATStatus logo of the status bar when in the
minimized state,
Queue level squares display the colors according
to the levels you preset. A quick glance at the screen
tell you the XWall queue status.
Message and Spam counts are displayed in different
colors in accordance with the Message bar
History Bar shows the last 32 hours of operation.
ESATStatus displays the worst level status of any queue
or a black field for none connection status. The history
bar is blank upon startup and will fill over the next
32 hours if ESATStatus stays active.
Message Bar display graphically the ratio of
spam verses good mail.
All message counts start at midnight or whenever XWall
was started. The history bar display starts when executing
ESATStatus.
On mouseover the labels of the different queues and
bars are displayed. Pointing the coursor over the ESATStatus
logo will bring up the configuration panel.
Pre Installation
MRTG=True
MRTGAllowIP=192.168.1.200
If you want to use a wildcard ip
MRTGAllowIP=192
Note: Substitute 192.168.1.200 with the IP address
of the machine you run ESATStatus on.
Note to XWall 3.0 users:
You may ran ESATSTatus with MRTGAllowIP= set to nothing.
This will not work in XWall 3.0. You must set it to
something. IP ranges will work.
|
